RMON log events are used to generate SNMP traps for PSU insertion and removal in both powered up and powered down states. SNMP traps generate while inserting or removing a powered up Power Supply Unit (PSU) without pulling out the power cable and also when removing a powered down PSU from the HP Switch 5406 Series. Proper Lansweeper host added as Permitted to RO SNMP.Lanweeper has proper SNMP Conmunity string and it attached to proper network. It has enabled and configured SNMP v2 (other monitoring system poll it without issue). Telnet to the router/switch prompttelnet testrouter Go to the enable mode by specifying the password: Router> enable Password: Router Go into configuration mode. Click Apply button on the top of the page. Lansweeper version: 5.3.0.33 Website version: 5333 I have Cisco 4500x switch. This article will guide your through the steps to enable SNMP in Cisco Routers and Switches.
Click Configure button and supply the parameters for SNMP or keep the defaults for general configuration. Click on MANAGE, navigate to Appliance SNMP. SNMP trap when power supply is inserted or removed Enable SNMP and configure SNMP parameters Login to the SonicWall management GUI as admin. The Simple Network Management Protocol (SNMP) can be very useful to collect information from network devices but can also pose a security risk if not configured properly.SNMP protocol uses a 'Community String' which acts as password for restricting access (Read Only or Read/Write).
0 kommentar(er)
